/**
 * \file
 *
 * \brief
 *
 * \copyright (c) 2015-2020 Microchip Technology Inc. and its subsidiaries.
 *
 * \page License
 *
 * Subject to your compliance with these terms, you may use Microchip software
 * and any derivatives exclusively with Microchip products. It is your
 * responsibility to comply with third party license terms applicable to your
 * use of third party software (including open source software) that may
 * accompany Microchip software.
 *
 * THIS SOFTWARE IS SUPPLIED BY MICROCHIP "AS IS". NO WARRANTIES, WHETHER
 * EXPRESS, IMPLIED OR STATUTORY, APPLY TO THIS SOFTWARE, INCLUDING ANY IMPLIED
 * WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY, AND FITNESS FOR A
 * PARTICULAR PURPOSE. IN NO EVENT WILL MICROCHIP BE LIABLE FOR ANY INDIRECT,
 * SPECIAL, PUNITIVE, INCIDENTAL OR CONSEQUENTIAL LOSS, DAMAGE, COST OR EXPENSE
 * OF ANY KIND WHATSOEVER RELATED TO THE SOFTWARE, HOWEVER CAUSED, EVEN IF
 * MICROCHIP HAS BEEN ADVISED OF THE POSSIBILITY OR THE DAMAGES ARE
 * FORESEEABLE. TO THE FULLEST EXTENT ALLOWED BY LAW, MICROCHIP'S TOTAL
 * LIABILITY ON ALL CLAIMS IN ANY WAY RELATED TO THIS SOFTWARE WILL NOT EXCEED
 * THE AMOUNT OF FEES, IF ANY, THAT YOU HAVE PAID DIRECTLY TO MICROCHIP FOR
 * THIS SOFTWARE.
 */

#ifndef SWI_UART_START_H_
#define SWI_UART_START_H_

#include <stdlib.h>
//#include <hri_sercom_v200.h>
#include "atmel_start.h"
#include "cryptoauthlib.h"


/** \defgroup hal_ Hardware abstraction layer (hal_)
 *
 * \brief
 * These methods define the hardware abstraction layer for communicating with a CryptoAuth device
 *
   @{ */


/** \brief
    - this HAL implementation assumes you've included the ASF SERCOM UART libraries in your project, otherwise,
    the HAL layer will not compile because the ASF UART drivers are a dependency *
 */

#define MAX_SWI_BUSES    6  // SAMD21 has up to 6 SERCOMS that can be configured as UART

#define RECEIVE_MODE    0   // UART Receive mode, RX enabled
#define TRANSMIT_MODE   1   // UART Transmit mode, RX disabled
#define RX_DELAY        10
#define TX_DELAY        93
/** \brief this is the hal_data for ATCA HAL for ASF SERCOM
 */
typedef struct atcaSWImaster
{
    // struct usart_module for Atmel SWI interface
    struct usart_sync_descriptor USART_SWI;
    uint32_t                     sercom_core_freq;
    int                          ref_ct;
    // for conveniences during interface release phase
    int bus_index;
} ATCASWIMaster_t;

ATCA_STATUS swi_uart_init(ATCASWIMaster_t *instance);
ATCA_STATUS swi_uart_deinit(ATCASWIMaster_t *instance);
void swi_uart_setbaud(ATCASWIMaster_t *instance, uint32_t baudrate);
void swi_uart_mode(ATCASWIMaster_t *instance, uint8_t mode);
void swi_uart_discover_buses(int swi_uart_buses[], int max_buses);

ATCA_STATUS swi_uart_send_byte(ATCASWIMaster_t *instance, uint8_t data);
ATCA_STATUS swi_uart_receive_byte(ATCASWIMaster_t *instance, uint8_t *data);
/** @} */

#endif // SWI_UART_START_H_