e(s) found ERROR: USB_MAX_HUB (%d) reached usb_pgood_delayCan't allocate memory for USB device! Port %d over-current occurred %d times cannot reset port %i!? cannot create new device: ret=%dPort not available. lowlevel init failed USB error: all controllers failed lowlevel init scanning bus %d for devices... No USB Device found %d USB Device(s) found USB%d: EHCI fail to reset USB EHCI %x.%02x usb_new_device: Cannot read configuration, skipping device %04x:%04x ERROR: NOT USB_CONFIG_DESC %x ERROR: Invalid USB CFG length (%d) ERROR: Invalid USB IF length (%d) USB IF descriptor overflowed buffer! Too many USB interfaces! ERROR: Invalid USB EP length (%d) USB EP descriptor overflowed buffer! Endpoint descriptor out of order! Interface %d has too many endpoints! ERROR: Invalid USB EPC length (%d) USB EPC descriptor overflowed buffer! EPC descriptor out of order! failed to set default configuration len %d, status %lX selecting invalid interface %d%s: invalid max packet size Cannot allocate device context to get SLOT_ID USB device not accepting new address (error=%lX) 12 Mb/s+- %s (%s, %dmA) %s %s %s %s failed to stop USB controller %d Did not get interrupt on CBI cmd 0x%02X returned 0x%02X 0x%02X 0x%02X 0x%02X (NOT READY) cmd 0x%02X returned 0x%02X 0x%02X 0x%02X 0x%02X error in inquiry Device NOT ready Request Sense returned %02X %02X %02X READ_CAP ERROR No storage devices, perhaps not 'usb start'ed..? scanning usb for storage devices... max USB Storage Device reached: %d stopping %d Storage Device(s) found USB Storage Transport unknown / not yet implemented Sorry, protocol %d not yet supported. ERROR: %s - start address is not aligned - 0x%08x ERROR: %s - stop address is not aligned - 0x%08x ## No elf image at address 0x%08lx ## Not a 32-bit elf image at address 0x%08lx U-Boot 2017.11+fslc+ga07698f (Sep 10 2018 - 21:06:01 +0000)Error: no valid bmp image at %lx Error: compression type %ld not supported 4bpp bitmap unsupported with current