#![no_std]
#![no_main]

/**
  Transmits data over an SPI port using DMA
*/
use panic_halt as _;

use cortex_m_rt::entry;
use stm32f1xx_hal::{
    pac,
    prelude::*,
    spi::{Mode, Phase, Polarity, Spi},
};

#[entry]
fn main() -> ! {
    // Get access to the device specific peripherals from the peripheral access crate
    let dp = pac::Peripherals::take().unwrap();

    // Take ownership over the raw flash and rcc devices and convert them into the corresponding
    // HAL structs
    let mut flash = dp.FLASH.constrain();
    let mut rcc = dp.RCC.constrain();

    // Freeze the configuration of all the clocks in the system and store the frozen frequencies in
    // `clocks`
    let clocks = rcc.cfgr.freeze(&mut flash.acr);

    // Acquire the GPIOA peripheral
    let mut gpiob = dp.GPIOB.split(&mut rcc.apb2);

    let hx711_spi_pins = (
    gpiob.pb13.into_alternate_push_pull(&mut gpiob.crh),
    gpiob.pb14.into_floating_input(&mut gpiob.crh),
    gpiob.pb15.into_alternate_push_pull(&mut gpiob.crh),
    );

    let hx711_spi = spi::Spi::spi2(device.SPI2, hx711_spi_pins, spi::MODE_1, 1.mhz(), clocks);
    let tim_delay = device.TIM1.delay::<1_000_000>(&clocks);
    let mut hx711_sensor = Hx711::new(hx711_spi, tim_delay);
    hx711_sensor.reset().unwrap();
    hx711_sensor.set_mode(hx711_spi::Mode::ChAGain128).unwrap(); // x128 works up to +-20mV

    // Set up the DMA device
    let dma = dp.DMA1.split(&mut rcc.ahb);

    // Connect the SPI device to the DMA
    let spi_dma = spi.with_tx_dma(dma.5);

    // Start a DMA transfer
    let transfer = spi_dma.write(b"hello, world");

    // Wait for it to finnish. The transfer takes ownership over the SPI device
    // and the data being sent anb those things are returned by transfer.wait
    let (_buffer, _spi_dma) = transfer.wait();

    loop {}
}