Stay awake for 10 minutes after batteries are inserted How long should the device associated to multi sensor keep state On before sending it Off command (if the value is bigger than 255, the value would be rounded to next integer in minutes) Enable Motion Sensor Which commands to send when PIR motion sensor triggered OZW Ideal Value is Binary Sensor Report Enable/disable the selective reporting only when measurements reach a certain threshold or percentage set in the threshold settings. This is used to reduce network traffic. Threshold change in temperature to induce an automatic report. Note: 1. When the unit is Celsius, threshold=Value. 2. When the unit is Fahrenheit, threshold=Value*1.8. The accuracy is 0.1. 3. The high byte is the part of integer, the low byte is the fractional part. Threshold change in humidity to induce an automatic report. Note: The accuracy is 0.1. The high byte is the part of integer, the low byte is the fractional part. Threshold change in luminance to induce an automatic report. Threshold change in battery level to induce an automatic report. Note: The accuracy is 0.1. The high byte is the part of integer, the low byte is the fractional part. Enable/disable to send the alarm report of low temperature(Less than 15 Degress C) Which reports need to send automatically in timing intervals for group 1. Bitsets: 0 -> Battery report, 5 -> Temperature, 6 -> Humidity, 7 -> Luminosity Which reports need to send automatically in timing intervals for group 2. Bitsets: 0 -> Battery report, 5 -> Temperature, 6 -> Humidity, 7 -> Luminosity Which reports need to send automatically in timing intervals for group 3. Bitsets: 0 -> Battery report, 5 -> Temperature, 6 -> Humidity, 7 -> Luminosity The interval of sending report group 1. 1 to 2678400 seconds The interval of sending report group 2. 1 to 2678400 seconds The interval of sending report group 3. 1 to 2678400 seconds Enable/disable Lock Configuration Reset to factory defaults.