Load will be closed when the Current overruns (US 15.5A, Others 16.2) for more than 2 minutes Configure the output load status after re-power on. Configure the RGB Led Color for Testing Defines the automated status notification of an associated device when status changes Configure the RGB Value when in Night Light Mode. Byte 1: Red Color Byte 2: Green Color Byte 3: Blue Color Configure the brightness level of RGB LED (0%-100%) when it is in Energy Mode/momentary indicate mode. Byte 1: Red Color Byte 2: Green Color Byte 3: Blue Color Enable/disable Wattage threshold and percent. The value represents the minimum change in wattage for a Report to be sent (default 25 W) The value represents the minimum percentage change in wattage for a Report to be sent (Default 5) Set report types for groups 1, 2 and 3 to default. Defines the type of report sent for reporting group 1. 2 is multisensor report. 4 is meter report for watts. 8 is meter report for kilowatts. Value 1 (msb) Reserved Value 2 Reserved Value 3 Reserved Value 4 (lsb) bits 7-4 reserved bit 3 KWH bit 2 Watt bit 1 Current bit 0 Voltage Defines the type of report sent for reporting group 1. 2 is multisensor report. 4 is meter report for watts. 8 is meter report for kilowatts. Value 1 (msb) Reserved Value 2 Reserved Value 3 Reserved Value 4 (lsb) bits 7-4 reserved bit 3 KWH bit 2 Watt bit 1 Current bit 0 Voltage Defines the type of report sent for reporting group 1. 2 is multisensor report. 4 is meter report for watts. 8 is meter report for kilowatts. Value 1 (msb) Reserved Value 2 Reserved Value 3 Reserved Value 4 (lsb) bits 7-4 reserved bit 3 KWH bit 2 Watt bit 1 Current bit 0 Voltage Set time interval for sending reports for groups 1, 2 and 3 to default. Defines the time interval when the defined report for group 1 is sent. Defines the time interval when the defined report for group 2 is sent. Defines the time interval when the defined report for group 3 is sent. Partner ID Enable/disable Configuration Locked Device tag. Reset to the default configuration.