Activate/Deactive ALL ON/OFF Choose which command classes are sent to associated devices. Choose the behaviour of transitions between different levels. Size of the step for each change in level during the transition. Time between each step in a transition between levels. Setting this to zero means an instantaneous change. 0 - immediate change; 1->63: 20ms->126ms (value*20ms); 65->127: 1s->63s (value-64)*1s; 129->191: 10s->630s (value-128)*10s; 193->255: 1min->63min (value-192)*1min. Default setting: 67 (3s) Maximum brightness level for the dimmer Minimum brightness level for the dimmer This is too complex to describe here, since this value is built up from 4-bits for each of the 4 channels. Refer to the table in the product manual. Default value is 4369 (1111 in hex). Option double click (lighting set at 100%). 0 - Double click disabled, 1 - Double click enabled. Default setting 1 Saving state before power faillure Alarm of any type (general alarm, water flooding alarm, smoke alarm: CO, CO2, temperature alarm). Default setting 0 (Inactive) Program number selected from the 10 available. In ALARM PROGRAM mode (see parameter 30), this defines the time in seconds the program lasts (1s->65534s) Specify which command class is used to report output status changes Parameter defines a value by which input voltage must change in order to be reported to the main controller. New value is calculated based on last reported value: Default setting: 5 (0.5V). Range: 1->100 - (0.1V->10V). Sent if last reported value differs from the current value. Reports will also be sent in case of polling. Default setting: 30 (30s). Range: 1->65534 (1s->65534s) - interval between reports. Zero means reports are only sent in the case of polling, or at turning OFF the device Interval between energy consumption reports (in kWh). New reported energy consumption value is calculated based on last reported value. 1->254 (0.01kWh->2.54kWh). Zero means changes in consumed energy will not be reported, except in case of polling. Set whether to remember the previous RGB mix after the brightness has fallen to zero (black) First predefined program to use when device is set to work in RGB/RGBW mode (parameter 14) Behaviour when an input is triple-clicked