After Power-On-Reset of the device, the Channel Output State is set in Default State This parameter allows unsolicited “Notification Report” Commands and/or “Basic Set” Commands to be sent when a power failure detection and/or a power failure recover occurs. Only the four least significant bits can be addressed. Bit 0: Enable or disable power failure detection and recover. Setting this bit to 1 automatically allows the product to send unsolicited report through Lifeline. If this bit is not set, it is not possible to enable Association Group 4, 5 and 6. Consequently, if a Configuration Set Command is received, enabling one or more Association Groups (4, 5 and / or 6), this bit will be automatically set. Bit 1: Enable or disable unsolicited Notification Report: Power Management – AC disconnected Command and Notification Report: Power Management – AC re-connected Command sent to associated nodes of Group 4, when, respectively, power failure is detected or power failure is recovered. Bit 2: Enable or disable Basic Set ON Command sent to associated nodes of Group 5, when power failure is detected. Bit 3: Enable or disable Basic Set OFF Command sent to associated nodes of Group 6, when power failure is detected. Bit 4: Enable or disable Basic Set ON Command sent to associated nodes of Group 7, when power recover is detected. Bit 5: Enable or disable Basic Set OFF Command sent to associated nodes of Group 8, when power recover is detected. This parameter allows Basic Set Commands to be sent when the channel output state changes (ON or OFF). Only the two least significant bits can be addressed. Bit 0: Enable or disable Basic Set Commands sent to associated nodes of Group 2, when Channel Output State changes. Bit 1: Enable or disable Basic Set Commands sent to associated nodes of Group 3, when Channel Output State changes. This parameter forces the channel output state to be always ON. It is not possible to turn OFF the channel output, which means that: * All Switch OFF Command is rejected * Basic Set OFF Command is rejected * Binary Switch OFF Command is rejected * Local Control does not toggle channel output state * Product cannot be triggered by unsolicited Notification Report Command and enters in Alarm Mode see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters see Appendix C - Description of Alarm Parameters