If not zero, automatically switch off/close blind after a user defined time If not zero, automatically switch off/close blind after a user defined time Time to go from opened to closed state. Used to estimate the current level. Note that in Permanent motion mode the reported value would a be Closed or Opened, while all Basic and Multilevel Set values (1-99, 255) would Open except 0 value that would Close. Time to go from closed to open state. This value may differ from Full close time for some blinds due to gravity. Used to estimate the current level. Note that in Permanent motion mode the reported value would a be Closed or Opened, while all Basic and Multilevel Set values (1-99, 255) would Open except 0 value that would Close. Id of the device which commands would be interpreted not as Open/Close, but as block/unblock. Usefull with door opening detector: if the door is open, block the blind not to break shades while they move. Defines which command from blocking device to interpret as closed door and hence, unprotected. Defines behaviour on open press while closing and vice versa. To allow Stop behavior when switched by remote, use Stop by Basic Allow exchanging open and close relays if blind control is wired to the motor incorrectly Typical time used to differentiate click, hold, double and triple clicks. If disabled, the local operations by buttons will not switch the load, but only send commands to On/Off association group. In this mode buttons are not linked with the switch anymore. They can be used separately: buttons to control remote device, switch will operate by RF commands only. Defines which command should be sent on button single press or hold. Basic commands are sent to Association group. Switch All commands are sent broadcast. Defines which command should be sent on button double press or press-hold. Basic commands are sent to Association group. Switch All commands are sent broadcast. If not disabled, the device will wait for a click timeout to see if the second click would be pressed. This will introduce a small delay for single click commands.