[default.probe]
# USB vendor ID
# usb_vid = "0d28"
# USB product ID
# usb_pid = "0204"
# Serial number
# serial = "12345678"
# The protocol to be used for communicating with the target.
protocol = "Swd"
# The speed in kHz of the data link to the target.
speed = 10000

[default.flashing]
# Whether or not the target should be flashed.
enabled = true
# Whether or not bytes erased but not rewritten with data from the ELF
# should be restored with their contents before erasing.
restore_unwritten_bytes = false
# The path where an SVG of the assembled flash layout should be written to.
# flash_layout_output_path = "out.svg"
# Triggers a full chip erase instead of a page by page erase.
do_chip_erase = false

[default.reset]
# Whether or not the target should be reset.
# When flashing is enabled as well, the target will be reset after flashing.
enabled = true
# Whether or not the target should be halted after reset.
halt_afterwards = false

[default.general]
# The chip name of the chip to be debugged.
chip = "PY32F030x6"
# A list of chip descriptions to be loaded during runtime.
chip_descriptions = ["PY32F0_Series.yaml"]
# The default log level to be used. Possible values are one of:
#   "OFF", "ERROR", "WARN", "INFO", "DEBUG", "TRACE"
log_level = "INFO"
# Use this flag to assert the nreset & ntrst pins during attaching the probe to the chip.
connect_under_reset = false

[default.rtt]
# Whether or not an RTTUI should be opened after flashing.
enabled = true
# How the target handles RTT outputs that won't fit in the buffer.  This can be
# overridden per-channel. If left unset, the firmware will determine the default
# for each RTT up channel.
#   NoBlockSkip - Skip writing the data completely if it doesn't fit in its
#                 entirety.
#   NoBlockTrim - Write as much as possible of the data and ignore the rest.
#   BlockIfFull - Spin until the host reads data.  Can result in app freezing.
#
# up_mode = "BlockIfFull"

# A list of channel associations to be displayed. If left empty, all channels are displayed.
# up, down (Optional) - RTT channel numbers
# name     (Optional) - String to be displayed in the RTTUI tab
# up_mode  (Optional) - RTT channel specific as described above
# format   (Required) - How to interpret data from target firmware.  One of:
#              String - Directly show output from the target 
#              Defmt  - Format output on the host, see https://defmt.ferrous-systems.com/
#              BinaryLE - Display as raw hex
channels = [
    { up = 0, down = 0, name = "RTT", up_mode = "NoBlockSkip", format = "String" },
]
# The duration in ms for which the logger should retry to attach to RTT.
timeout = 3000
# Whether timestamps in the RTTUI are enabled
show_timestamps = true
# Whether to save rtt history buffer on exit.
log_enabled = false
# Where to save rtt history buffer relative to manifest path.
log_path = "./logs"

[default.gdb]
# Whether or not a GDB server should be opened after flashing.
enabled = false
# The connection string in host:port format wher the GDB server will open a socket.
gdb_connection_string = "127.0.0.1:50001"