//! Draw a 1 bit per pixel black and white image. On a 128x160 sh1108 display over SPI.
//!
//! This example is for the STM32F103 "Blue Pill" board using SPI.
//!
//! Wiring connections are as follows:
//!
//! ```
//! Display -> Blue Pill
//!     GND -> GND
//!     VCC -> 3.3V or 5V (check your module's input voltage)
//!     SCK -> PA5
//!    MOSI -> PA7
//!      DC -> PA2
//!      CS -> PA1 (optional, connect to ground on module if unused)
//! ```
//!
//! Run on a Blue Pill with `cargo run --example image`.

#![no_std]
#![no_main]

use cortex_m_rt::{entry, exception, ExceptionFrame};
use display_interface_spi::SPIInterface;
use embedded_graphics::{
    image::{Image, ImageRawLE},
    pixelcolor::BinaryColor,
    prelude::*,
};
use embedded_hal::spi;
use panic_semihosting as _;
use sh1108::{prelude::*, Builder};
use stm32f1xx_hal::{prelude::*, spi::Spi, stm32};

#[entry]
fn main() -> ! {
    let dp = stm32::Peripherals::take().unwrap();
    let cp = cortex_m::Peripherals::take().unwrap();

    let mut flash = dp.FLASH.constrain();
    let rcc = dp.RCC.constrain();

    let clocks = rcc.cfgr.freeze(&mut flash.acr);

    let mut afio = dp.AFIO.constrain();

    let mut gpioa = dp.GPIOA.split();

    let mut res = gpioa.pa4.into_push_pull_output(&mut gpioa.crl);
    let sck = gpioa.pa5.into_alternate_push_pull(&mut gpioa.crl);
    let miso = gpioa.pa6.into_floating_input(&mut gpioa.crl);
    let mosi = gpioa.pa7.into_alternate_push_pull(&mut gpioa.crl);
    let dc = gpioa.pa2.into_push_pull_output(&mut gpioa.crl);
    let cs = gpioa.pa1.into_push_pull_output(&mut gpioa.crl);

    let mut delay = cp.SYST.delay(&clocks);

    let spi = Spi::spi1(
        dp.SPI1,
        (sck, miso, mosi),
        &mut afio.mapr,
        spi::MODE_0,
        400u32.kHz(),
        clocks,
    );

    let spi_interface = SPIInterface::new(spi, dc, cs);

    // If you don't need the Chip Select pin, use this instead:
    // let spi_interface = SPIInterfaceNoCS::new(spi, dc);

    let mut disp: GraphicsMode<_> = Builder::new().connect(spi_interface).into();

    disp.reset(&mut res, &mut delay).unwrap();

    disp.init().unwrap();
    disp.flush().unwrap();

    let im: ImageRawLE<BinaryColor> = ImageRawLE::new(include_bytes!("./rust.raw"), 64);

    Image::new(&im, Point::new(32, 0)).draw(&mut disp).unwrap();

    disp.flush().unwrap();

    loop {}
}

#[exception]
unsafe fn HardFault(ef: &ExceptionFrame) -> ! {
    panic!("{:#?}", ef);
}