//! Print "Hello world!" with "Hello rust!" underneath. Uses the `embedded_graphics` crate to draw //! the text with a 6x10 pixel font. //! //! This example is for the STM32F103 "Blue Pill" board using I2C1. //! //! Wiring connections are as follows for a CRIUS-branded display: //! //! ``` //! Display -> Blue Pill //! (black) GND -> GND //! (red) +5V -> VCC //! (yellow) SDA -> PB9 //! (green) SCL -> PB8 //! ``` //! //! Run on a Blue Pill with `cargo run --example text`. #![no_std] #![no_main] use cortex_m_rt::{entry, exception, ExceptionFrame}; use display_interface_i2c::I2CInterface; use embedded_graphics::{ mono_font::{ascii::FONT_6X10, MonoTextStyleBuilder}, pixelcolor::BinaryColor, prelude::*, text::{Baseline, Text}, }; use panic_semihosting as _; use ssd1309::{prelude::*, Builder}; use stm32f1xx_hal::{ i2c::{BlockingI2c, DutyCycle, Mode}, prelude::*, stm32, }; #[entry] fn main() -> ! { let dp = stm32::Peripherals::take().unwrap(); let cp = cortex_m::Peripherals::take().unwrap(); let mut flash = dp.FLASH.constrain(); let rcc = dp.RCC.constrain(); let clocks = rcc.cfgr.freeze(&mut flash.acr); let mut afio = dp.AFIO.constrain(); let mut gpiob = dp.GPIOB.split(); let mut res = gpiob.pb7.into_push_pull_output(&mut gpiob.crl); let scl = gpiob.pb8.into_alternate_open_drain(&mut gpiob.crh); let sda = gpiob.pb9.into_alternate_open_drain(&mut gpiob.crh); let mut delay = cp.SYST.delay(&clocks); let i2c = BlockingI2c::i2c1( dp.I2C1, (scl, sda), &mut afio.mapr, Mode::Fast { frequency: 100u32.kHz(), duty_cycle: DutyCycle::Ratio2to1, }, clocks, 1000, 10, 1000, 1000, ); let i2c_interface = I2CInterface::new(i2c, 0x3C, 0x40); let mut disp: GraphicsMode<_> = Builder::new().connect(i2c_interface).into(); disp.reset(&mut res, &mut delay).unwrap(); disp.init().unwrap(); disp.flush().unwrap(); let text_style = MonoTextStyleBuilder::new() .font(&FONT_6X10) .text_color(BinaryColor::On) .build(); Text::with_baseline("Hello world!", Point::zero(), text_style, Baseline::Top) .draw(&mut disp) .unwrap(); Text::with_baseline("Hello Rust!", Point::new(0, 16), text_style, Baseline::Top) .draw(&mut disp) .unwrap(); disp.flush().unwrap(); loop {} } #[exception] unsafe fn HardFault(ef: &ExceptionFrame) -> ! { panic!("{:#?}", ef); }