//! Interfacing the on-board L3GD20 (gyroscope)
#![deny(unsafe_code)]
// #![deny(warnings)]
#![no_main]
#![no_std]

#[macro_use(entry, exception)]
extern crate cortex_m_rt as rt;
extern crate cortex_m;
extern crate panic_semihosting;
extern crate embedded_hal as ehal;
extern crate stm32l4xx_hal as hal;

use cortex_m::asm;
use crate::hal::prelude::*;
use crate::hal::spi::Spi;
use crate::rt::ExceptionFrame;
use crate::ehal::spi::{Mode, Phase, Polarity};

/// SPI mode
pub const MODE: Mode = Mode {
    phase: Phase::CaptureOnFirstTransition,
    polarity: Polarity::IdleLow,
};

#[entry]
fn main() -> ! {
    let p = hal::stm32::Peripherals::take().unwrap();

    let mut flash = p.FLASH.constrain();
    let mut rcc = p.RCC.constrain();

    // TRY the other clock configuration
    // let clocks = rcc.cfgr.freeze(&mut flash.acr);
    let clocks = rcc.cfgr.sysclk(80.mhz()).pclk1(80.mhz()).pclk2(80.mhz()).freeze(&mut flash.acr);

    let mut gpioa = p.GPIOA.split(&mut rcc.ahb2);
    let mut gpiob = p.GPIOB.split(&mut rcc.ahb2);

    // let mut nss = gpiob
    //     .pb0
    //     .into_push_pull_output(&mut gpiob.moder, &mut gpiob.otyper);

    let mut dc = gpiob
        .pb1
        .into_push_pull_output(&mut gpiob.moder, &mut gpiob.otyper);


    // The `L3gd20` abstraction exposed by the `f3` crate requires a specific pin configuration to
    // be used and won't accept any configuration other than the one used here. Trying to use a
    // different pin configuration will result in a compiler error.
    let sck = gpioa.pa5.into_af5(&mut gpioa.moder, &mut gpioa.afrl);
    let miso = gpioa.pa6.into_af5(&mut gpioa.moder, &mut gpioa.afrl);
    let mosi = gpioa.pa7.into_af5(&mut gpioa.moder, &mut gpioa.afrl);

    // nss.set_high();
    dc.set_low();

    let mut spi = Spi::spi1(
        p.SPI1,
        (sck, miso, mosi),
        MODE,
        // 1.mhz(),
        100.khz(),
        clocks,
        &mut rcc.apb2,
    );

    // nss.set_low();
    let data = [0x3C];
    spi.write(&data).unwrap();
    spi.write(&data).unwrap();
    spi.write(&data).unwrap();
    // nss.set_high();

    // when you reach this breakpoint you'll be able to inspect the variable `_m` which contains the
    // gyroscope and the temperature sensor readings
    asm::bkpt();

    loop {}
}

#[exception]
fn HardFault(ef: &ExceptionFrame) -> ! {
    panic!("{:#?}", ef);
}