zmq_tipc(7) ========== NAME ---- zmq_tipc - 0MQ unicast transport using TIPC SYNOPSIS -------- TIPC is a cluster IPC protocol with a location transparent addressing scheme. ADDRESSING ---------- A 0MQ endpoint is a string consisting of a 'transport'`://` followed by an 'address'. The 'transport' specifies the underlying protocol to use. The 'address' specifies the transport-specific address to connect to. For the TIPC transport, the transport is `tipc`, and the meaning of the 'address' part is defined below. Assigning a port name to a socket ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ When assigning a port name to a socket using _zmq_bind()_ with the 'tipc' transport, the 'endpoint' is defined in the form: {type, lower, upper} * Type is the numerical (u32) ID of your service. * Lower and Upper specify a range for your service. Publishing the same service with overlapping lower/upper ID's will cause connection requests to be distributed over these in a round-robin manner. Connecting a socket ~~~~~~~~~~~~~~~~~~~ When connecting a socket to a peer address using _zmq_connect()_ with the 'tipc' transport, the 'endpoint' shall be interpreted as a service ID, followed by a comma and the instance ID. The instance ID must be within the lower/upper range of a published port name for the endpoint to be valid. EXAMPLES -------- .Assigning a local address to a socket ---- // Publish TIPC service ID 5555 rc = zmq_bind(socket, "tipc://{5555,0,0}"); assert (rc == 0); // Publish TIPC service ID 5555 with a service range of 0-100 rc = zmq_bind(socket, "tipc://{5555,0,100}"); assert (rc == 0); ---- .Connecting a socket ---- // Connect to service 5555 instance id 50 rc = zmq_connect(socket, "tipc://{5555,50}"); assert (rc == 0); ---- SEE ALSO -------- linkzmq:zmq_bind[3] linkzmq:zmq_connect[3] linkzmq:zmq_tcp[7] linkzmq:zmq_pgm[7] linkzmq:zmq_ipc[7] linkzmq:zmq_inproc[7] linkzmq:zmq_vmci[7] linkzmq:zmq[7] AUTHORS ------- This page was written by the 0MQ community. To make a change please read the 0MQ Contribution Policy at .