pegasus_astro
| Crates.io | pegasus_astro |
| lib.rs | pegasus_astro |
| version | 0.1.0 |
| source | src |
| created_at | 2022-05-31 08:16:19.884886 |
| updated_at | 2022-05-31 08:16:19.884886 |
| description | Multiplatform drivers for PegasusAstro equipment with a bit of gRPC |
| homepage | |
| repository | https://github.com/devDucks/pegasus-rs/ |
| max_upload_size | |
| id | 597353 |
| size | 62,754 |
Mattia Procopio (MattBlack85)
documentation
README
pegasus-rs
Multiplatform drivers for pegasus equipment written in Rust.
This driver is meant to communicate with all pegasus powerboxes on all major platforms.
Run locally (UNIX/Windows)
Be sure to have rust installed (if you don't have rust check here and
simply run on your terminal/cmdshell cargo run
Build a debug version of the program (UNIX/Windows)
in your terminal type cargo build
Build an optimized version of the program AKA the version that will run for real (UNIX/Windows)
in your terminal type cargo build --release
Pegasus PPBA protocol instructions
| Command | Description | Response |
|---|---|---|
| P# | Status | PPBA_OK |
| PE:bbbb | Set Power Status on boot. Every number represents 1-4 power outputs. (0=OFF, 1=ON). |
PE:1 |
| P2:nn | ON/OFF Power 8V DSLR (0=OFF, 1=ON) n can also accept values of: 3, 5, 8, 9, 12 (Volts) |
P2:nn |
| P3:nnn | PWM Duty Cycle Power 5 (DewA) X=0-255 (0-100%) |
P3:nnn |
| P4:nnn | PWM Duty Cycle Power 6 (DewB) X=0-255 (0-100%) |
P4:nnn |
| PF | Reboot Device / Reload Firmware | [none] |
| PA | Print Power and Sensor Readings | [Check table below] |
| PS | Prints Power Consumption Statistics | PS:averageAmps:ampHours:wattHours:uptime_in_millisec |
| PC | Print Power Metrics | *Current is represented in Amps and does not require conversion. PC:total_current:current_12V_outputs: current_dewA:current_dewB:uptime_in_ millisec |
| PR | Prints discovered I2C devices plugged to EXT port | PR:HDC:DHT:XS if there is a discovered device command will output its name HDC = temp/humidity sensor TI HDC1050 DHT =stock temp/humidity sensor AM2301 XS: eXternal Motor (stepper) Controller |
| DA | (Auto) Dew Aggressiveness from 0 to 255 (210 default value) | DA:nnn |
| PD:b | Enable/Disable Auto Dew Feature (X=0,1) PD:99 Reports Auto Dew Aggressiveness value |
PD:nnn |
| PV | Firmware Version | n.n |
| PI | Reset I2C channel | PI:1 |
| PL:b | OF/OFF Led Indicator (0=OFF, 1=ON) | PL:b |